Spectrum TrafficLine is a fast drying, high-build line marking paint that can be used for almost all line marking applications. TrafficLine is ideal for use on hard surfaces such as roads, car parks, distribution centres, airports and docks. TrafficLine is an epoxy product, which means that it is lower in solvent content than other products such as chlorinated rubber and very resistant to fuels & oils. TrafficLine can be applied by roller, brush or spray methods and comes in 5 & 20 Kilogram tins in a choice of colours.
FIND OUT MORE ABOUT ENVIRAPAC:
Features & Benefits:
- Line marking paint approved for use on airfields
- Can be manufactured to any RAL colour, with short lead times
- Hard-wearing product, well proven in demanding locations
- Excellent adhesion to concrete and asphalt surfaces; this includes traditionally difficult surfaces such as blocks and pavers
Surface preparation: The application surface should be sound and clean, free from grease, oil, rust, scale, dirt, or any other soiling that might affect adhesion or performance. In any case, but especially in the case of overcoating existing line markings, it is further recommended that test areas be coated to ensure good adhesion and/or compatibility with the substrate.
Asphalt – weathered - It is recommended that asphalt and other similar surfaces be allowed to thoroughly harden for up to 6 months before painting. Test trials should be carried out in the first instance on a small area.
Concrete & other cementitious surfaces – including powerfloat, tamped or brushed concrete, monoblocks & pavers – Ensure surface is sound, clean and free from laitance – we recommend a preparation method suitable for the specific location and surface is carried out before application of product, to ensure surface is properly prepared back to clean and sound substrate.
Examples of preparation methods that may be suitable are captive shot blasting, diamond grinding, scabbling or planing. It is critical that utmost attention is paid to cleanliness and good workmanship, whatever preparation method is used, as the presence of any loose material, dust, soiling or previous coatings are likely to reduce adhesion of new coatings.
New concrete should be left to harden before coating, as the curing process and residual moisture content can lead to product delamination if coated too early.
Asphalt & tarmacadam - no primer required
External concrete, pavers & monoblocks - use FP Line Primer
Internal powerfloated concrete - use Etch Primer or FP Line Primer
Mixing instructions: Stir thoroughly before use.
Thinning: This product is supplied ready to use and need not be thinned. If thinning is required, Type 2 Thinners may be used, up to 20% by volume.
Application: We recommend the use of airless spray equipment for best finish; if applying with roller or brush, product may need to be thinned with Type 2 thinners, to retard drying times & reduce premature hardening on roller or brush
Touch dry: 10 minutes @ 15⁰C.
Walk on time: 15 minutes @ 15⁰C.
Traffic time: 30 minutes @ 15⁰C.
Full cure: 90 minutes @ 15⁰C
Recoat: 1-2 hours @ 15⁰C.