High quality acrylic line marking paint for any surface delineation/marking, excellent adhesion and mechanical resistance. Typical uses for this product are any type of exterior ground delineation, such as car park, walkway and stencil marking, also hazard zoning and lean management.
Features And Benefits:
- Unique nozzle
- Excellent adhesion
- Fast drying
Concrete: Before applying Tracing on new concrete, wait for 3 to 4 weeks to allow the concrete to dry
(DTU standard) and the acid evaporation
Greater amounts of aerosol will be required for line marking on coarser concrete.
Asphalt: It is advisable to wait at least 15 days before marking on a new asphalt coating to avoid damage to the paint. Depending on the climate conditions after laying the asphalt, this period may have to be extended by one or two weeks.
Painted Ground: Many types of paints are used on ground surfaces and there may be problems of compatibility with Tracing (problems of adherence). There are also flexible ground paints which will require the application of a flexible line paint, in which case Tracing will not be suitable. In these very special cases, a test should be carried out to check paints compatibility.
Shake the can vigorously upside down to mix the paint thoroughly (even after balls rattle).
Manually or with our application equipment (4-wheel trolley, 2-wheel applicator and pistol handle)
Upside Down use, adjust height of application thanks to used equipment in accordance with your required line width
Before use: Shake the can vigorously upside down to mix the paint thoroughly even after balls have been heard clearly
The surface to be painted must be well prepared for an excellent adherence of the paint.
Clean surface to be free of dust, dirt and grease…
At the time of application, surface must be dry and temperature not less than 5°C for optimal performances.
Lines can be covered by our varnish Protect Line(P44.000) to increase time lasting and dirtiness resistance
WARNING: A trial test must be done on synthetic (plastic, PVC type…) or recent paint covered (Epoxy, PUR type…) backgrounds. Please contact our technical department
AFTER use: Purge in upright position (until only gas is released), to clean the valve and diffuser.
Do not apply when the air or surface temperature is below 5°C or less than 3°C above dew point, or if this is likely to occur during the curing period.
Do not apply when there is rain, mist, fog, or snow imminent; when humidity is high or the surface is wet with condensation or likely to be during the drying period.
Touch dry: 5 to 10 mins @ 15⁰C.
Traffic Time: 15-20 min (depending on temperature)