RouteLine is a chlorinated rubber line marking paint, that provides cost-effective, fast drying lines that are compatible with most surfaces.It is a single-pack product which is fully sprayable and is ideally suited for applications such as dockside, container handling and storage sites, rail platforms and other applications where lines have an essential functionality and which require regular re-marking to maintain visibility.It is an approved product for airfield use
FIND OUT MORE ABOUT ENVIRAPAC:
Features and Benefits
- Fast drying for rapid return to service
- Can be used both internally and externally
- Meets the requirements for use on airfields and rail platforms
- Can be sprayed using airless spray equipment
- Can be reflectorised with glass beads
The application surface should be sound and clean, free from grease, oil, rust, scale, dirt, or any other soiling that might affect adhesion or performance. In any case, but especially in the case of overcoating existing line markings, it is further recommended that test areas be coated to ensure good adhesion and/or compatibility with the substrate.
Asphalt – weathered - It is recommended that asphalt and other similar surfaces be allowed to thoroughly harden for up to 6 months before painting. Test trials should be carried out in the first instance on a small area.
Concrete & other cementitious surfaces – including powerfloat, tamped or brushed concrete, monoblocks & pavers – Ensure surface is sound, clean and free from laitance – we recommend a preparation method suitable for the specific location and surface is carried out before application of product, to ensure surface is properly prepared back to clean and sound substrate.
Examples of preparation methods that may be suitable are captive shot blasting, diamond grinding, scabbling or planing. It is critical that utmost attention is paid to cleanliness and good workmanship, whatever preparation method is used, as the presence of any loose material, dust, soiling or previous coatings are likely to reduce adhesion of new coatings.
New concrete should be left to harden before coating, as the curing process and residual moisture content can lead to product delamination if coated too early.
Asphalt & tarmacadam - no primer required
External concrete, pavers & monoblocks - use FP Line Primer
Internal powerfloated concrete - use Etch Primer or FP Line Primer
Mix thoroughly with power stirrer before use.
We recommend the use of airless spray equipment for best finish; if applying with roller or brush, product may need to be thinned with Type 2 thinners, to retard drying times & reduce premature hardening on roller or brush.
Do not apply when the air or surface temperature is below 5°C or less than 3°C above dew point, or if this is likely to occur during the curing period.
Do not apply when there is rain, mist, fog, or snow imminent; when humidity is high or the surface is wet with condensation or likely to be during the drying period.
Touch Dry: 10 minutes @ 20°C
Traffic time: 15 minutes @ 20°C