High quality acrylic line marking paint with a satin finish, superb for interior delineation of walkways and other health and safety markings. Typical uses for this product are; any type of interior delineation, such as line, walkway and stencil marking, also hazard zoning and lean management.
All surfaces must be free of any dust, damp or contamination. Concrete: Before applying Tracing on new concrete, wait for 3 to 4 weeks to allow the concrete to dry (DTU standard) and the acid evaporation. Greater amounts of aerosol will be required for line marking on coarser concrete. Asphalt: It is advisable to wait at least 15 days before marking on a new asphalt coating to avoid damage to the paint. Depending on the climate conditions after laying the asphalt, this period may have to be extended by one or two weeks. Painted Ground: Many types of paints are used on ground surfaces and there may be problems of compatibility with tracing (problems of adherence). There are also flexible ground paints which will require the application of a flexible line paint, in which case Tracing will not be suitable. In these very special cases, a test should be carried out to check paints compatibility
Shake the can vigorously upside down to mix the paint thoroughly (even after balls rattle).
Manually or with our application equipment (4-wheel trolley, 2-wheel applicator and pistol handle)
Upside Down use, adjust height of application thanks to used equipment in accordance with your required line width
Before use: Shake the can vigorously upside down to mix the paint thoroughly even after balls have been heard clearly
The surface to be painted must be well prepared for an excellent adherence of the paint.
Clean surface to be free of dust, dirt and grease…
At the time of application, surface must be dry and temperature not less than 5°C for optimal performances.
For a good quality line, the first application must be a thin coat. The second and possibly third must be carried out more slowly so that a good deposit of paint is achieved.
Lines can be covered by our varnish Protect Line(P44.000) to increase time lasting and dirtiness resistance
WARNING: A trial test must be done on synthetic (plastic, PVC type…) or recent paint covered (Epoxy, PUR type…) backgrounds. Please contact our technical department
AFTER use: Purge in upright position (until only gas is released), to clean the valve and diffuser.
Touch dry: 5 to 10 mins @15oC
Drying Time: 15-20 min (depending on temperature)