DekorCryl is an acrylic co-polymer emulsion, specifically formulated as an additive for void-sealer slurry coats used for sealing porous, bituminous substrates in preparation for the application of resin bond coats. Kit now comes with a unique powder within the bucket to ensure consistent application.
Features and Benefits:
- No Need for additional materials
- Consistent slurry mixture
- Helps to prevent bleeding of bitumen
- Once laid, the void filler helps to maintain correct coverage of resin
All surfaces to be sealed should be thoroughly clean and dry. Any oil contamination should be thoroughly washed away using a mild detergent.
Open the outer carton and remove the kit contents. Open the Dekorcryl liquid compound and stir well using the mixing stick supplied. Pour the liquid compound into outer bucket and slowly add the powder compound - for best
The slurry mixture is poured on to the surface and spread using a flat squeegee, forcing the material into the surface texture and leaving a membrane of no more than 1mm over the surface.
Temperature of application: Recommended surface temperature during application should be between 5°C and 30°C.
Do not apply when the air or surface temperature is below 5°C or less than 3°C above dew point, or if this is likely to occur during the curing period.
Do not apply when there is rain, mist, fog, or snow imminent; when humidity is high or the surface is wet with condensation or likely to be during the drying period.
The drying time of DekorCryl is approximately 2 hours in a warm dry atmosphere. As the material is an emulsion, humidity will greatly affect the drying time and heavy rain will wash away newly laid material away. As well as the surface becoming totally dry, the surface needs to become hard prior to the application of resins.
Care must be taken to ensure the DekorCryl has fully cured before applying any DekorGrip resin system.